Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / md. jahidul alam
RYB is a three phase connections phase sequence which are
apart 120 degree from each other and they are in positive
sequence.
| Is This Answer Correct ? | 70 Yes | 7 No |
Post New Answer View All Answers
distribution is maximum done by a)radial b)network c) parallel d)b & c
Write down the design procedure of commutaj.
Grid fault level [KA]?
What Is Sampling?
how the works electronic energy meter?
how maney type tempereture measurement ?
why are distributed windings generally used in alternators?
why co incidence factor considered in transformer sizing?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
What are the advantages of the three-phase motor over single phase motor?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
how to check regenerative load in drived motor
what is fault level of power system ?
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
