Interested to Buy Any Domain ? << Click Here >> for more details...
How many straight through joint is permissible in single
core 33kv XLPE cable for a length of 985 mtr.
- 3 Answers
- 9205 Views
- DMRC, I also Faced
- E-Mail Answers
Answer Posted / ankush mitra
1
| Is This Answer Correct ? | 11 Yes | 4 No |
Post New Answer View All Answers
State Maximum Power Transfer theorem.
Is RTCC panel needs any control supply.
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
What is the source of dependent source ?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
What is Plank's Law?
Iin ESP why positive is grounded ? why not negative ?
Percentage losses in power generation?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
Explain the operation of grid connected central solar inverter ?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
