HELLO FRIENDS PLZ EXPLAINE ME WHAT IS ORIFICE?AND HOW WE
ARE USING IT IN INSTRUMENTATION
- 5 Answers
- 7233 Views
- Wartsila, I also Faced
- E-Mail Answers
Answer Posted / joby
oriface plate can be used a primary sensing element for
differential pressure transmitters.basic principle is to
make restrictions in flow to obtain differential
pressure.which will be directly proposional to the flow
rate.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
what is loop1 and loop2 in MTS LT?
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
What is the purpose of LO Overhead tank in turbines.
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
Who to difference between analog in & analog out in dcs?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
what is the reason while warning lamp is on while the engine is cranking?
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
Draw a great bridge circuit.
how to turbine speed measurement?
