Answer Posted / aamirali
USA use above for safety & economical reasons. Observe synchronous speed (Ns=120f/P)and output power in watts (P=1.732VI). so, you can design your equipment with less power rating & also less rpm for rotating machines as compared to 50hz, 220ac v. Saving the cost & minimize the electrical accidents.
| Is This Answer Correct ? | 8 Yes | 5 No |
Post New Answer View All Answers
How to calculate or formula to calculate rhe power in 2 phase system ??
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
Explain using drawings what is reverse PID action w.r.t PID controllers.
Transmission through a short line depends on
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
Why squirrel cage motor can only use with low starting loads ?
for a 400kv t/m line with 10 ampere current will corona occur?
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
what is your aim
in india per day how much power is generated including all power station
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
why the check zone and main zone are used for Busbar Protn. scheem?
Explain what is use of lockout relay in ht voltage?
