Interested to Buy Any Domain ? << Click Here >> for more details...
why do we use 4-20 ma current why cant o-20ma
- 6 Answers
- 21830 Views
- Southwest Cheese, I also Faced
- E-Mail Answers
Answer Posted / m.mohan
4 MA
LIVE ZERO DEAD ZERO CONCEPT
20MA
ELECTRICALLY UPTO 20MA THERE IS NO CREATING A SPARK
IN THE TIME OF SHORTED LOOP.ALSO CURRENT TRAVELLING LONG
DISTANCE WITHOUT NO DROP.(UPTO 1500m)
the main purpose for choosing 4to 20ma easily convert to
voltage to add 250 ohms resistance with the help of ohm's
law
| Is This Answer Correct ? | 8 Yes | 9 No |
Post New Answer View All Answers
What is force balance principle?
Why boiler chimney area oxyden sensor fixing?
what is diffrance between FF & SMART, explain with difination
types of cable..? Use of every types of cable..?
components of control circuit belongs to control valve
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
how many type conductivity sensor ?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
What are different types of orifice plates?
How to Calibrate Flow Switch in field
Emergency Shutdown Systems/ Plant Shutdown System.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
How to Calibrate Level Troll in field
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
