Interested to Buy Any Domain ? << Click Here >> for more details...
if voltage is not builed up in small generator what will be
the reason?
- 7 Answers
- 11046 Views
- century, I also Faced
- E-Mail Answers
Answer Posted / shakir
there are so many reasons:
1.the exciter might have problem
2.the ac produced in exciter is converted into dc before
supplying it to the rotor.the diodes used for this purpose
might have problem.
3.when u start the generator there should be a residual
magnetism to induse the voltage.if u will not use the
generator for long time, it will loose that residual
magnetism.for that purpose u have to give flash over
voltage.
4. the exciter winding might be grounded.
5. the input (D.C.from voltage regulator)voltage to the
exciter is not enough to create flux in the exciter.
6.faulty stator winding
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Write down the name of 2 lady Bir Pratin of Bangladesh
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
how to introduce yourself
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
should %impedance be high or low in a power transformer? if so why?
what do u understand from filter factor of reactor?
What is the effect of positive feedback on the stability of the systems?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
Difference between Lugs and Thimbles
what are all types of cross section in AC cables?
why does rotor rotets?
