how to set the transformer differential relay
- 1 Answers
- 5853 Views
- Divis Laboratories, I also Faced
- E-Mail Answers
Answer Posted / g.baladhandapani
For Numeric type relay differential settings should be 30%
AND HF will be 8 Times and other settings will be as per
the Relay mannual
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
What is the disadventage of gland earthing(power cable) if any. ?
show the single line diagram of star delta starter with single phase preventer
How to calculate the time setting for star connection in star delta starter? For example 10KW 3PH Induction motor.
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
How it can worked plc based electrical system And which type of software using.
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
what is meant by moulded case circuit breaker ?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
What is the diffrence (Technical & Construction ) between CBCT & Normal CT?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
What is a surge supressor why its is used in synchronous generators
