Interested to Buy Any Domain ? << Click Here >> for more details...
why do we use 4-20 ma current why cant o-20ma
- 6 Answers
- 21829 Views
- Southwest Cheese, I also Faced
- E-Mail Answers
Answer Posted / chandrasekaran.n
This is only concept of live zero & dead zero.live zero is
4ma.because if any faulty in your sensor are signal
transmitting field cable are your power source fuse failure
you can easily find out that live zero concept.
| Is This Answer Correct ? | 33 Yes | 2 No |
Post New Answer View All Answers
What is the Working principle of Dozing valve?
why we are using magnet for calibration of gas detector?
What is the meaning of wet leg
Why is the orifice tab provided?
What is the use of temperature compensation?
What are the interlocks we have to check during the start up of LP/HP compressor?
Explain an adaptive / self-tuning controller’s major draw card.
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Boolean algebra
Explain the use of hair spring in the pressure gauge.
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
what are the values of fuel flow rate in various places in boiler.
Operational amplifiers
