Interested to Buy Any Domain ? << Click Here >> for more details...
why do we use 4-20 ma current why cant o-20ma
- 6 Answers
- 21630 Views
- Southwest Cheese, I also Faced
- E-Mail Answers
Answer Posted / shazly
it gives us the ability for knowing if there is cuttig in
the wire.but if we use 0-20 if there is a cutting in the
wire it will indicate also 0 which we have and i will not
give us any idea if there is cutting or not
| Is This Answer Correct ? | 30 Yes | 6 No |
Post New Answer View All Answers
Can I calibrate the Electromagnetic Flow Meter on line and How.
where proximity sensor installed on tank in loading arm application
what are the selections available in configuring a burnout protection of a controller? thanks
What is profibus?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
How can measure flow in oil line?which type of transmitter is generally used?
What is the difference bitween control net scaner and device net scaner
Full form of KKS when use DCS.
How to check vortex flow meter is in good condition while we do not having calibration setup?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
give some question relative instrument fitter?
what is sliding spool valves?
