what will happen if we double the input frequency of a
transformer keeping the voltage constant?
- 6 Answers
- 22437 Views
- I also Faced
- E-Mail Answers
Answer Posted / shinde kv
when we applied double freq. that time eddy current losses
increase means iron losses will be increase hence increase
the heat loss.
| Is This Answer Correct ? | 8 Yes | 14 No |
Post New Answer View All Answers
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
What is the actual calculation for transformer short circuit test?.
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
why we change the direction of winding in rotor ?how we make the north and south pole?
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
what is the carona effects meaning in HT line transmmission system
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
Do inductive loads have distorted current waveforms ?
how to compute kvar in substation feeder to improve power factor and sending voltage
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
how can see the ac indoor or out door ac which Tr
