Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERENCE BETWEEN VOLTage and potential diff
- 5 Answers
- 8977 Views
- I also Faced
- E-Mail Answers
Answer Posted / umesh kumar
Potential diff. is the amount of work done to move a +ve
charge from one point to other specified point is Called
Potential diff.
voltage is themeasuring unit of Potential difference
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
why dc is used in control circuit for mv & hv switchgear instead of ac
what is your majour contributions in your present job
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
WHAT IS MEANT BY DERATING OF THYRISTOR?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
what is W.T?specify the acceptable range?
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
How Diesel Generator start ?
what is earth pit , how we can measured it, what earth rods reference
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
What is difference between Over Current & Earth Fault protection?
2. What are the parameters of EHT sub-station?
Why does curving the pole faces in a dc machine contributes to a smoother dc output voltage from it?
