how you confirm the hard stratum for driven cat in situ
pile work?
- 2 Answers
- 4894 Views
- I also Faced
- E-Mail Answers
Answer Posted / sachin pawar
to confirm the hard statum for driven cast in situ piles,
check the specific gravity of stone obtained while boring
the piles. it should be between 2.77 to 3.08
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is the largest concrete dam in the world?
What the advantages and disadvantage of using 90mm and 100mm bricks for a wall of a house? Thanks for any input.
Critical Path Method is...
what is difference between NP2 NP3 NP4 CONCRETE HUME PIPES USED AT SITE
Can anyone tell me the sequence of the activities in a drawing room, kitchen & Toilet including civil work, finishing, electrical & plumbing fittings
rate analysis for cement pointing 1:4 , for 100 sq m
Exterior Joints,define
in staad pro. modelling for a parallel scissors chord truss, when i assigned roller support i.e fixwd but with all Fx, FZ, Mx, My and Mz release except Fy... the analysis results " in stability at a joint, with direction Mx or My..what could be the reason...anyone please explaing
What is Rankine Cycle?
How much cement and water required for cement selery????
undistributed samples are obtained by
How to produce the Concrete Grade 30mpa at 12hour? How to prevent for plastic shrinkage crack? How can we produce fire resistant concrete?
What happens to Load at yielding ?
How many hours should traffic be not allowed after completing wbm road or bst.and min how many hours should road rollers be used.
what is Bearing Capacity,How to determine it?
