Interested to Buy Any Domain ? << Click Here >> for more details...
How can we calculate the fault level of the distribution
system knowing the percentage impedance of transformer &
subsequent equipments.
- 14 Answers
- 60075 Views
- I also Faced
- E-Mail Answers
Answer Posted / avatar
When deciding the fault levels, isnt there a time component
as well? I have seen the fault levels being designated
as "350 MVA @ 1 sec". What does this mean? Please help.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
iam preparing for rrb section engineer post in electrical branch.suggest the right textbook for my reference.fromwhere i will get the previous q.papers?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
Dry type transformers
What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
what are the analog quality input for protection function?what are minimum reqiments?
Generator,motor and alternator Working principal Please explain easily
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
what is working process of star delta controlling circuit ?
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
