Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between RTU & MTU in SCADA system?
- 4 Answers
- 50636 Views
- Bosch, I also Faced
- E-Mail Answers
Answer Posted / manish
I think MTU is also known as Master terminal unit.
And its main purpose is to accept the diffrent inputs from
the Remotely connected devices and transmitt them over the
network
| Is This Answer Correct ? | 66 Yes | 11 No |
Post New Answer View All Answers
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
How digital input and digital output 's are working in dcs
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
Why mmwc unit is used?
How to Calibrate Flow Switch in field
How is flow measured in square root?
What is Span Error
draw shematic diagram of c/v positioner(smart type)?
where cascade loop use ?
use of split range ? where it is used ? in which control loop it is used ?
Explain why plc require in analog input 4-20amp & 0-10 volt?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
why we are using magnet for calibration of gas detector?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
