Interested to Buy Any Domain ? << Click Here >> for more details...
when we calibrate the DP transmitter at that time which
matrial we used in pressure pump?
- 4 Answers
- 7312 Views
- I also Faced
- E-Mail Answers
Answer Posted / divyesh
if pressure pump is hydrolic then oil or water is used and
if pressure pump is penumetic teen only air.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
where proximity sensor installed on tank in loading arm application
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
What is the reason PT speed not incresed in gas turbine?
What is furnace draft control?
what is the difference between active & reactive power?
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
in mass flow meter what is drive friquancy ?
what is actual drum level and compensated drum level?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
what is IEC code in cables & how to selecting cables?
