Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gk3000
You can use Q = sq.root of DP
where Q = Flow rate
DP = differential pressure.
| Is This Answer Correct ? | 17 Yes | 6 No |
Post New Answer View All Answers
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
how can leve transmetter calibate in feild .and also put cv and flow plz .....
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
What is stripper & spilitter ? Diffrence in this.?
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
please send the drdo exam paper
How to Calibrate Ultrasonic Level Transmitter in field
Difference between dcs and plc including date processing and architecture.
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
please send data bank of quetions answers on analytical instrumentation.
How servomotor controls throttle valve of TURBINE?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
