what is relation between voltage and current and don't take
resistance here.
if we supose say when there is increase in voltage whwt
happens to current?is it decrease or increase?
Answer Posted / h s dhillon
It is further added to my answer that if a fixed amount of
power is to be transmitted, higher the voltage, lower will
be the current
Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
Which type of DG need Netral Earthing?
What is the power factor of an alternator at no load?
whats the application of voltage regulation? and whats the voltage regulation's device?
what is the importance of Partial Dischage test for Electrical Equipments
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
What is steady state response?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
what is meant by the phrase 'static load' in case of shorting in a generator excitation system?
what is meant by directional earth fault and non directional earth fault? describe both.
explain working principle of earth leakage relay
1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor
any application of back emf