Interested to Buy Any Domain ? << Click Here >> for more details...
6.6 KV /.415KV Step down trf. we can get 6.6 KV from
primary by applying .415 KV secondary side by same TRF.
- 3 Answers
- 7897 Views
- Suzlon, I also Faced
- E-Mail Answers
Answer Posted / b soni
You we will be get the out put of 6.6kv becoz the induced
emf ratio is same as primary to secondary
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
The synchronous machine excitation system explain
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
how much flux density of CRNO core
What are the advantages of the three-phase motor over single phase motor?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
What’s electric traction?
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
how many joints are allowed in underground HT cable of 1 KM
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
What is inrush current?
how rectifier transformer work in electroststic precipetatore(esp?
Instrument connected to a single phase supply
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
why using transformer and thyristor switch in 3 phase apfc panel
