Answer Posted / ganguly
there are two types of speed control for dc motor
1. armature control method
by connecting the additional resistance to the armature,
but this will use below rated seeds only
2.field controlmethod
by connecting the resistance to the field
but this will use above rated speeds only
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is th basic difference between a d latch time line and a d flip flop time line???
Is there any specialised book to refer about fault level calculation both in MV and LV side??
how can we make cable shedule for controll wiring ? which details must be required for it.?
Write the force balance equation of ideal spring element.
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
What is signal flow graph?
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
How to Calculate the Fault Level of Electrical Installation
what are the parameters plays a major role in Potential transformer Burden calculation??
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
What is inrush current?
how we can set the IDMT relay.
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
how to calculation increase power factor for single phase
