Interested to Buy Any Domain ? << Click Here >> for more details...
If mVolts can drop by resistance of wire as compare to mA,
then how thermocouple mV reaches in CCR as accurate value?
- 7 Answers
- 10431 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh
Each type of themocouple different types of metals winding are used Example k-type of thermo couple used cromium aluminium metals are used, like j,s,t ect. This metals used as per thermo couple mvolts droping is reducedu
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the process for double acting cylinder pneumatic for 32' v/v
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
What is the diffrence between digital signal processing and discrete signal processing?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what would be the minimum flow rate that we can measure on rotameter..?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
What are the types of valves?
Full form of KKS when use DCS.
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
