Answer Posted / komal

HMI & MMI both are same.
HMI is a harware device by whcih we can control the process
by changing status such as ON/OFF, cetpoint etc,
SCADA is a graphical representation of a system which
monitor,control & display data in a process,
For lage scale application we use SCADA & for small scale
application we use HMI.
HMI does not require any communication software while scada
requires it.

What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?

15417

---

why we are not using the turbine flow meter in the steam service?

2179

---

what is the calibration procedure for magnetic flow meter @ onsite

1621

---

Hi, Is there any smart plant instrumentation design training institute in Bangalore?

1632

---

What is the difference between uv and ir scanners? and what is the workig principle of both

2340

---

What is instrumentation instrumentation engineering?

1069

---

Question on maha cement

707

---

how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?

1858

---

What is the GK Value in Flowmeter?

3659

---

Why boiler chimney area  oxyden sensor fixing? 

2441

---

how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???

2381

---

Please asked me How calculate DCS controller memory.

2746

---

while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?

2166

---

Conversions

2102

---

There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?

1923

---