Interested to Buy Any Domain ? << Click Here >> for more details...
11kv has three live wires how much voltage is in its single
wire(leaving the other two wires)
- 13 Answers
- 74276 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / aboli
Vtg.can not be measured with single wire.
| Is This Answer Correct ? | 32 Yes | 23 No |
Post New Answer View All Answers
why we r not earthed Control cable of C.T. terminals
what is acceptance test in electrical engineering.
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
Why we use circular(Stepped) cross section in transformer core?
why genarator genarating voltage 11 KV?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how to calculate cooling requirement of datacentre from electrical load?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
how to calculate
2. A current i=(10+10 sin t)amperes is passed through MI type ammeter. its reading will be.........
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
Mention the disadvantages of low power factor? How can it be improved?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
