Answer Posted / ginto
yes it is the compression ring and next one is oil ring
| Is This Answer Correct ? | 25 Yes | 0 No |
Post New Answer View All Answers
What is elasticity and explain its types?
The amount of radiation emitted per scm per sec is called …. ?
If we heat the rod what will happen,draw stress & strain curve before after heating ?
Preparation before arriving port?
all mrf company details
Why would you use hydraulics rather than pneumatics?
Hi! Greetings of the day. Can somebody tell me about as built duct sheet area calculation method. As we know that for this purpose A = (W+H)*2*L. But I have query about multiplication factors for elbows, tappers, offsets etc if there is any. Also refer the papers if available. Please revert. Thanks in advance.
Are you ready to relocate with your immediate family as a new employee?
What is compound gage
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
What is defrence between relaction & refraction?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
aptitutude and technical questions asked in HPCL MECHANICAL ENGG TEST PAPER. IF ANY ONE HAS SAMPLE PAPERS .PLEASE SEND ME ON MY E-MAIL ID . goyal.nirmal@gmail.com. plz
What happen when too much cylinder oil is injected in the working cylinder?
Can any one plz help me to find aptitude questions on UG.NX software??
