Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dhaval
in ac always form factor is 1.414 it is ratio of rms value
and average value buat in dc no rms value then dc form
factor is 0
| Is This Answer Correct ? | 3 Yes | 12 No |
Post New Answer View All Answers
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
why dc is used in control circuit for mv & hv switchgear instead of ac
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What is a feedback in control system?
Define closed loop control system.
What are the advantages of stationary armature and rotating field system?
what is 30-phase of transformer
describe the Operation of induction generators from bus bars
Why neutral cable carry current.
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
how the works electronic energy meter?
What are the advantages & disadvantages of a group electrive drive?
What does the term power factor shows?
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
