Interested to Buy Any Domain ? << Click Here >> for more details...
why the Current transformers secodary is shorted to ground
(In metering and Protection)
- 2 Answers
- 6320 Views
- I also Faced
- E-Mail Answers
Answer Posted / guru
The purpose of grounding the CT secondary is inorder to
protect the CT circuit in case of any earth fault in the CT
secondary circuit. Thus even there is an earth fault & the
CT is open the current will still circulates through the
ground to CT. It prevents the accidental open circuit in
the CT which may lead to develop a high potential in
secondary which may lead to CT blast.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
which network topology offers the greatest level of tolerance?
what is the standard duration after failure EB power
HOW TO TEST A LIGHTENING ARREST ER ?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
How will be the single line diagram of series trip HT breaker? how it works?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
How to calculate wire length,size & current? ( related to control panel)
Electrical 'C' license full abbreviation , and full form
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
How many points does a Circuit can have?
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
66kv under ground cable how to layaing in ground any special case two ckt r runing
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
