how can we check a fully charged battery?
- 6 Answers
- 8772 Views
- BEML, Singareni Collieries, I also Faced
- E-Mail Answers
Answer Posted / raghavendran
Consider a 12 volt battery having 6 cells and each cell
charged to 2 volts.When the cell is fully charged then the
total voltage across the battery will show 12.6 volts under
no load condition.Then it means that cell is 100% charged.
2) if it shows 12.4volts, then its 75% charged.
3) if it shows 12.2 Volts then it is 50% charged.
4) if it shows 12.0 volts then it is 25% charged.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
how the phase convertor changes the no. of phases
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
What is inrush current?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
What is rotating magnetic field?Discuss elaborately.
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
why not starting switch first connect in direct on line starter?????
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
What are protections for dty type transformers
how to modify DOL control panel into Delta Y connection?
