why generally transformer are in star to delta or delta to
star used?
- 8 Answers
- 18714 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / hareesh k soman
There r two reasons for the star and delta connection.. one
is load requirement i.e if load is un balanced we will go
for star.. i.e neutral will ground the fault current where
the delta will use for balanced load.
other reason is insulation requirement .. i.e in Power
transformer HV side will be star connected and LV side will
be delta connected. for example in 220kV/132kV power
transformer, in star connected HV line to line voltage is
220kV and phase voltage is 127kV i.e its required lesser
insulation. but in delta connected system V line= V phase
i.e 220kV insulation is required. but star only 127kV is
required...
| Is This Answer Correct ? | 41 Yes | 6 No |
Post New Answer View All Answers
Explain few advantages of electric traction system?
How the annunciator works ? How to do its wiring
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
hi, could someone help me to find a control design for syncronising panel .
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
how can i get an electrical c-certificate?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
difference bewteen reverse current and alternating current
Which type of transformer is used for lighting loads?
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
What is block diagram?
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
1.how many types of relays? 2.difference between ATS& STS?
