Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERENCE BETWEEN SHOP DRAWINGS/ DESIGN
DRAWINGS AND AS BUILT DRAWINGS??
- 2 Answers
- 30003 Views
- ACC, Al-Jaber, Dubai Group, ECEC, I also Faced
- E-Mail Answers
Answer Posted / hamid
the shop drawing is engineering DWG and may can be
change during the construction or installation of
equipment after test .
the Hasbult drawing is the final drawing after
commissionning of installation and the last change if it
has a changement
| Is This Answer Correct ? | 16 Yes | 8 No |
Post New Answer View All Answers
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
Is it true online ups having bypass mode if it is true then why we called ups because it is interrupting power when goes in bypass mode
How can we increase fuel-power ratio of any DG set?
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
Can RCD's used to protect the VVVF drive if not why.
what is the mechanical safety of DG ?
Why 9KV surge arrester having 7.65KV of MCOV?
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
how much LT load can bear by the 100 KW HT connection.
Iin ESP why positive is grounded ? why not negative ?
11KV AND 22KV NETWORK KW CAPACITY IN RING AND RADIAL?
what about electrical pannel.? What is meant by plc pannel.?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
