Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean CT Saturation? How to calculate?
- 13 Answers
- 113625 Views
- NCC, I also Faced
- E-Mail Answers
Answer Posted / faheem
Answer #6 is absolutely right I want to add one thing in it that when once a ct got saturated then it tends to built higher voltage on secondary side then normal due. as normally there is very less voltage on secondary side.
| Is This Answer Correct ? | 13 Yes | 15 No |
Post New Answer View All Answers
What is the capacity of the Fastners 12mm?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
Explain the working principle of Synchronous Generator and Assynchronous generator?
List the power rating of any 5 important electrical appliances used in houses.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is diff btw electric,magnetic & eletromagnetic field
In MEP Services what are parts of STP and what are there function?
What will be the diameter of pipe between conservation tank and transformer
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
how to calculate units consumption for a 12 hp motor /hr.
What is the BS(British Standard)code for 11kv motor
what is gridrotor resistance starter
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?
