Answer Posted / anil bhatia
1. Check the resistance of all windings. In case of three
phase motors resistance of all windings should be same.
2. Check the insulation resistance with megger. It should be
near about 1M-Ohm.
i am agrred by the statment given by friend but also in
some cases both above1 and 2 we find ok and problom we
find in iduction reactance which only can be measured by
motor checker .
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
In motors how many types of cooling systems were used?
What is s-domain and its significance?
1 Ton is equal to how many watts?
what is package substation.how many types they have
What is the general power factor & min. power rating of TV,LCD type TV, CRt type TV, Scanner, printer?
Under wat condition statcom operates as an inductor for the transmission line?
Briefly describe your ideal job?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
What is meant by stator?
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
What is the difference between DOL starter and star delta starter