What type of DC Generator is used for Arc Welding purposes?
- 7 Answers
- 37245 Views
- CPCL, Rubicon, I also Faced
- E-Mail Answers
Answer Posted / madhusudhana
The generator used in welding purposes should have high
current and low voltage which can be obtained by
differential compound generator. You dont get low voltage on
high current for a dc shunt generator.
| Is This Answer Correct ? | 40 Yes | 6 No |
Post New Answer View All Answers
How to select a contactor? How many types of contactors are available
What is Negative Potential Bias
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
I AM FROM ELECTRICAL ENGINEERING ? I AM ASPIRING FOR "BHEL".HOW I HAVE TO PREPARE .ON WHICH TOPICS TO BE CONCENTRATE MORE.PLEASE GIVE FULL DETAILS OF WRITTEN EXAM.
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
why should the primary of transformer be connected in delta in a heat run test?
Why do power lines not short out when they fall into water?
What are the advantages and disadvantages of closed-loop control system?
what is the purpose of bypass mode in energy lighting transformer?
What are the advantages of stationary armature and rotating field system?
quantizer means?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
what about SAP/MRP regarding manufacturing of electric motors and all drives?
