What is the difference between expansion joints & thermal
expansion joints in Bus bar
Answer Posted / aditya hivalkar
i think expansion joints on busbars are at the extream end of it. these are provided for joining other busbar of additional panel at both ends of switchboards. thus utilising these joints we can add additional panels.
thermal expansion joints are used at the place where busduct terminates on switchboard busbar. when heavy current flows through busbar its busbar expands due to heat, this expansion put lot of pressure on switchboard's busbar. this may result in breakdown of switchboards busbar. so thermal expansion joints allows the busducts busbar to expand.
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE
what is the difference between changer, converter and transformer?
what is negative and zero impedance in 3 phase induction motor ??
What is tranformer differtial?
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
Which do you think is the most significant cause of energy loss in a factory?
In synchronization circuit what is the function of Interposing voltage transformer(IVT)and Reverse voltage transformer(RVT)
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
what is the solution for meger test failed the MV cable?
What is knee point voltage of transformer?
Any Electrical Engineering jobs?Please refer for interviews. Thank you
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
What is kirchoff ’s current law (kcl)?
What is meant by reset level of the relay?
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?