Interested to Buy Any Domain ? << Click Here >> for more details...
how can we check a fully charged battery?
- 6 Answers
- 10166 Views
- BEML, Singareni Collieries, I also Faced
- E-Mail Answers
Answer Posted / ruthie
It could be checked by finding out the voltage across the
teminals using a voltmeter. The voltage obtained is then
cross-checked with the reference battery voltage at full
charge.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
What is the source of dependent source ?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
i want to model paper for section engg.
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
what is rating boiler
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
what is the common earth
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
how to calculate percentage impedence at 75 deg C at normal tap
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
