Answer Posted / parth belani
when there is a frequent requirement of some application
(for example, square or cube of numbers) in some program,
if every time we do the calculation, the length of the
program can become very large. In such applications, we use
the look-up table to considerably reduce the size of the
program. Look up tabe is a predefined table in which one
answer is corresponding to every number. for example, 1-->1
2-->4, 3-->9, 4-->16.... will be the look-up table for the
square of a number. Whenever in the program, there is an
application of squaring a number, we don't need to do the
calculation. what we need to do is just to relate that
number with the one against it in the look-up table. We
need to reserve required amount of memory for the look-up
table.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
I completed iti in2004 I was worked in A grade contractor can I get c licence
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
george phenomenon of synchronous machine
While testing a ZCT what parameters have to check or measure?
How i can calculate current of cable according to ares?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
why burdens of VTs is more than CTs?
aternator every parts and its working
Difference between On Line capacitor and Station Type capacitor.
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
What is the drawback of static coefficients?
why use phase displacement in transformer.and effect of phase displacement on transformer
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
what is earthing.how we make it,describe briefly.
what is load despatching
