Interested to Buy Any Domain ? << Click Here >> for more details...
Explain the working principle of servomotor
- 20 Answers
- 55333 Views
- ABB, Bhel, FANUC, GE, Jindal Steel and Power, L&T, SIA, Steelco Gujarat Ltd, I also Faced
- E-Mail Answers
Answer Posted / naveen mm
it works on the principle that ferro magnetic movable part
alligns itself along the direction of least reiuctance.
| Is This Answer Correct ? | 16 Yes | 24 No |
Post New Answer View All Answers
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
explain remenance . differentiate high remenance type ct & low remenance type ct
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
How much load can take a 16 mm aluminum cable 3 phase
why impedance relay is used for medium transmission line protection
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
when elecromagnatic waves are propogated in a wave guide?
