Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mvvsn murthy
In single phase system, nothing will happen. If there is any
higher current flowing and any short circuit occurs neutral
fuse will blown off if it is weaker than fuse in phase and
hence electrical apparatus will not work.
But in 3 phase system, we should not provide fuse in neutral
link, why because, even if we divide the loads equally in
three phases, some time, some of the loads may be switched
off. At that time load will not be balanced. During that
time neutral fuse blows off if any reason, phase voltage
will be increased where the load is less compare to the
other phases which causes electrical apparatus in that phase
will burn.
| Is This Answer Correct ? | 10 Yes | 13 No |
Post New Answer View All Answers
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
Why you want to join non technical field when you are an engineer?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
In radial network the source is fed from 1 end both ends at central
How to calculate the phase to phase clearness of HT /// LT bus bar?????
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
types of central Air conditioner plant?
what is the use of the puls transformer in UPS & how it works???????????
How to perform a DC resistance test In Alternator and their proceduces?
is it possible to start a motor in felid connected to a remote mcc
Which motor will you choose which can operate in both lagging as well as leading power factors?
Rules and standards of electrical control wiring ?
why swinburnes test cannot be performed on series machines?explain
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
