Answer Posted / km
when the protection trip is operated and the has not open
for less than a one second or depend upon our setting it
will gives an alarm.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
What is the minimum underground tank size capacity considered for firefighting purpose?
Can a generator runs after getting 1st stator earth fault.
What is zero of the system?
How can we convert 11 kv to 440 volt without using transformer ?
what is vtg limit of earth and neutral at transformer side?
surge tank, hrc fuse, earthing transformer, firm power objective type
Refernce currents are to be generated using refernce cueernts how can this be done??
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
WHAT IS THE PARTIAL DISCHARGE TEST?
How good are you in resolving the commercial issues to Employer's advantage?
what happen ehen synchronisation is done at below rated speed
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
what is the difference between circular wdg & ractangular wdg?
how you configure motorvision relay (L&T make)from DCS