Interested to Buy Any Domain ? << Click Here >> for more details...
A distribution transformer giving afrequency of 200HZ,
where it is rated for 50HZ. when it will occure?
- 2 Answers
- 4713 Views
- I also Faced
- E-Mail Answers
Answer Posted / hari krishna
transformers are exclusively for change of voltage only, if
the transformer output frequency is 200HZ it means that
transformer input frequency is also 200HZ.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
wht is embedded systems? what is new inthis field?
What is a surge supressor why its is used in synchronous generators
how diside ct mf exmp.200/5 ct
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
Inductor and capacitor........power in one phase and ...... in it another phase.
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What does the term supermesh means?
low frequency protection why recomend?
What is time invariant system?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
How LT megger works ?
