Interested to Buy Any Domain ? << Click Here >> for more details...
what type of relays used in transformers?
- 24 Answers
- 66674 Views
- APTransco, BSNL, I also Faced
- E-Mail Answers
Answer Posted / sethu siva & mainkandarama
1)Differential protection (If transformer is more than 5
MVA :As per IS 2026)
2)Restricted earth fault protection
3)Stand by earth fault protection
4)O/C & E /F protection (if required)
5)Over flux (V/F)
Auxiliary protections
1)B' relay protection
2)PRV
3)Oil temp. high trip
4)Winding temperature high trip
5)OSR
Alarms:
1)Winding temp. high alarm
2)Oil temp. high alarm
3)MOG alarm
| Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
how can decide the current rating of oltc
Why do we use copper cable for HT Supply and why not Aluminium?
what is gridrotor resistance starter
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
number of I/O devices in siemense plc
What are the types of class b amplifier?
what is the id1 & id2 setting in differential protection relay of CSPC?
How can I known multiplying factor .without multiplying table
Transmission through a short line depends on
why we testing the core balance of the transformer before comissioning?
