resistance switching is used in case of- ?
a. air blast CB b. bulk oil CB c. minimum oil CB d.
all types of CB
- 4 Answers
- 11348 Views
- HCL, SSC, I also Faced
- E-Mail Answers
Answer Posted / sulthana
The resistance switching is used in case of air blast
circuit breakers. so the answer is 'a'.
| Is This Answer Correct ? | 32 Yes | 4 No |
Post New Answer View All Answers
what is the purpose of silicon dropper used in battery charger?
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
can i connect REF and Differencial relay in 1 CT core for transformer protection?
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
what is the difference between interconnection and intraconnections in the circuit diagrams
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
c++ write a program to use a fuction call "max"which accepts an intger arrey of size5.as an arrument and return the larger and smallest of the arrey to main without changing. the original changing of the original position of the element of the arrey.
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
what is the voltage between earth & neutral in 3 phase electrical connection.
Write a note on Treatment for electric shock.
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
