Answer Posted / rakesh
Current is nothing but the rate of flow charge through the
conductor. Voltage is nothing but the potential between the
terminals.
Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is the formula of frequency ?
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Why temperature rise is conducted in bus bars and isolators?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
what is different between phase and netural
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Pleae send me last 5 years of Question book about RRB chennai.
what is th basic difference between a d latch time line and a d flip flop time line???
How many double suspension hardware fittings are required on a double circuit transmission tower?
In which of the following case, the rotating magnetic field is reversed? A regenerative breaking B plugging C dynamic breaking D forward motoring
How efficiency of thermal plant can be improved?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?