Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chinmay
Hook-ups are basically of two types Process Hook-Ups and
Pneumatic Hook-Ups. hook ups give complete information
required for installation of a particular instruments which
indicates cable entries, support details, connection sizes.
It clearly defines the instrumentation scope for
installation and helps in identifying the materials and
accesories required during installation
Process Hook-Ups covers all field instruments installed on
pipelines/vessels and other process equipments and
Pneumatic Hook-ups covers all instruments which require
instrument air to operate
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
how to design orifice plate?what is the equation?
Explain the combusion chamber
Why grounding is necessary? Give example with diagram.
how many types of spped sensors n vibration sensors?their basic principle n connection?
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
How to calculate P,I&D value in PID controller ?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Describe how to use megger to measure the earth resistance and insulation resistance
Explain how thw analog to digital converter works with the circuit diagram
Explain the burnout feature.
What are different type of instrument cable
IN CONTROL VALVE SPECIFICATIONS GENERALLY TERM " DE- 200" ."DM -400"USED,, WHAT IS DE/ DM STANDS FOR?
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
how to calibrate 0- 150 psi presure gauge by dead weght tester
