Answer Posted / sindhejs
Basically isolator is an switch manually used to off the
circuit.Isolator with fuse unit can do function of breaker
that is over load tripping by fuses.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
what is meant by twilight switches 7 where its applicable ?
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
Explain The Application Of Storage Batteries?
What is the use of bundle conductors?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
What is difference between Over Current & Earth Fault protection?
why the India electrical supply transmission loss is high when compare to us
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
Why is back emf used for a DC motor? Highlight its significance.
Why squirrel cage motor can only use with low starting loads ?
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
derive DC RMS value for half wave rectifier?
What is the unit of attenuation?
