Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashok
BIS means Bureau of Indian Standards
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
How to decide whether A / B / C / D curve type MCB should be used?
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
what is the importance of Partial Dischage test for Electrical Equipments
what is mathed of check the D.C MOTOR 181 KW (ARMATURE AND FIELD) WHAT IS THE MATHED OF CHECK THE THYRISTOR MODULE (HIGH CURRENT)
What is the operating principle of turbo-generator.
Explain about retrofitting of machine tool.
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
what is fault level of power system ?
How many types of faults are there in 3 phase power system?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
what is the mechanical safety of DG ?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
