in case of three phase induction motor,when it is connected
to three phase supply,why the magnetic field is rotets
around the armeture?
Answer Posted / sindhejs
Since the suplly is of 3 phase sinusoidal in nature, flux
produced due to htis in the stator is of alternating in
nature.This flux is cut by the stationary conductor on the
rotor, thus eddy currents are induced in the rotor circuit
by Lenz's law.To overcome force produced by these currents
and induced flux the rotor starts rotating in the direction
of flux.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
How to calculate the multiplying factor for energy meter with ct ratio given
What is negative sequence over voltage element?
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
what is the use of permanent magnet generator in exciter
I want single line diagram for AMF & DG syncronizing panel
3phase cable calculation formula by motor load
please send me the L&T Emb. sys. placement papers and entire details of pattren
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
how to calculate the earth fault current
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
Lt motor sfu flashing reasons?