Interested to Buy Any Domain ? << Click Here >> for more details...
what's the reson that,Load is not same on VFD I/P and O/P
Side.whenever DOL condition load is same I/P and O/P side.
- 2 Answers
- 5969 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant kumar sharma
Input frequency and Voltage at the VFD is constant but at
the output at the VFD is variable.
secondly the power factor at the Driven end is changing wrt
to load.
more over the Active and reactive part of Power is
deviating wrt to above factors thus the power at the input
and output of VFD are different.
in DOL none of the parameter like Voltage or Frequency are
changed thus Power remain same.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is zero elevation and zero suppression?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
all types of liquid analyzer principle with drawing?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
What is the purpose of the analyzer in petrochemical plant?
why we are using drum level control valve air to close?
What are the application of bernoulli’s theorem?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
Turbidity analyzer working principle ?
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
