Answer Posted / sindhejs
Oil is used for the two purpose,
1. For the purpose of insulation between primary n
secondary.
2. For the purpose of cooling of the windings.
Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
What are the advantages and disadvantages of negative feed back?
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
List out the the types of Mounting Light fixture?
How generating electric power export to grid from the generating station ?
can anyone give an idea about dia calculation in cold rolling mill
Why are iron cores in transformers made laminated?
what is the difference between oil surge relay and buchholz relay.
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
what is plunger and what's the use of it in motor alignment?
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
what is earthing.how we make it,describe briefly.
What are the types of excitation system?
Benifits of 3ph 4 wire metering over 3ph 3 wire
electrical ques