What is the total resistance between points ‘A’ and ‘B’ in
the given circuit
Answer Posted / ajay
if the ckt. is a cube type and each side is of 1ohm then
the total resistance between the two opposite corner is 5/6
ohm
and if u want to calculate the result just see the flow of
cuurent and u will see which resistor are in parallel or in
series.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is op-amp?
Write the total description of Ultra Commissioning.
Hai Frds, i want to join in testing tools course, pls sugest good institute. And pls tel about Mind Q institute & phone num of Nareswar Roa sir plss, ple mail me plssssss
please explain the meaning of "In GSM only 30 or 35 peoples can call at at time in a singal carrier but In CDMA apprx 70 peoples can call in a singal carrier at a time."..........
Explain in detail the thevenin`s theorem
Define what are the main purposes for which a cc amplifier may be used.
Why can’t we use comparator to convert sin wave into square wave?
SIR,i am applying for the jr.engineer(signal)post.kindly if you send some previos sample question -answer i will be higly obliged
What is q-factor of the coil?
Hi dears, i work with E// switches since a bit time,i faces a problem with AFFILE output,when i get the out put (with Hex code) and i try to convert it to ASCII code it gives me the correct values but the data is not arrange correctly,there is some tabs,spaces and by result the data is shifted is there any advice for this case thanks & regards
How to convert binary to gray code and vice-verse?
how to design an ups and battery connections for ups .
What is the difference between plc and dcs control system?
What are the requirements for producing sustained oscillations in feedback circuits?
i completed my b.tech.i want to prepare for civils. when new batch classes will start at rc reddy. plz mail me rajesh.mc28@gmail.com