Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between the microcontroller and PLC?
- 9 Answers
- 37645 Views
- HAL, Havells, I also Faced
- E-Mail Answers
Answer Posted / as a friend
micro controller is used for only particullar programming
but plc reprogrmmable device very easy to handle very easy
to reprogram it.
| Is This Answer Correct ? | 16 Yes | 7 No |
Post New Answer View All Answers
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
What is Cavitation in a control valve?
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
What is sensitivity in vibration probes..?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
how to calibrate 0- 150 psi presure gauge by dead weght tester
what are the different types of Protocols? & their applications.
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
how can leve transmetter calibate in feild .and also put cv and flow plz .....
what about your moleg in pogrees with company
What is offset in a control system.
what is intrinscily safe system and where we use?
