Answer Posted / geneliya disuza
by using LED LAMPS AND ALSO CFL LAMPS
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
can i use 2000/5A Clamp meter to measure HT cable
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
what is earth pit , how we can measured it, what earth rods reference
What are the factors which influence the choice of specific magnetic and electric loadings of a synchronous machine?
what is the difference between b c d curves on mcb
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
why would amp draw on neutral wire be as much as amp draw on the hot leg.
What is the general system requirement of alternator?
what are the advantages and disadvantages of oil filled cables over XLPE cables
Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.
